Cont. v
WARNING! - Ignoring the following may result in injury or damage to equipment
SAFETY
Where there is conflict between EMC and Safety requirements, personnel safety shall always take precedence.
• Never perform high voltage resistance checks on the wiring without
first disconnecting the drive from the circuit being tested.
• Whilst ensuring ventilation is sufficient, provide guarding and /or
additional safety systems to prevent injury or damage to equipment.
• When replacing a drive in an application and before returning to use,
it is essential that all user defined parameters for the product’s
operation are correctly installed.
• All control and signal terminals are SELV, i.e. protected by double
insulation. Ensure all external wiring is rated for the highest system
voltage.
• Thermal sensors contained within the motor must have at least
basic insulation.
• All exposed metalwork in the Drive is protected by basic insulation
and bonded to a safety earth.
• RCDs are not recommended for use with this product but, where
their use is mandatory, only Type B RCDs should be used.
EMC
• In a domestic environment this product may cause radio interference
in which case supplementary mitigation measures may be required.
• This equipment contains electrostatic discharge (ESD) sensitive
parts. Observe static control precautions when handling, installing
and servicing this product.
• This is a product of the restricted sales distribution class according
to IEC 61800-3.
• It is designated as “professional equipment” as defined in
EN61000-3-2. Permission of the supply authority shall be obtained
before connection to the low voltage supply.
To Next Page
Loading...
