Parker 890CS - Page 239

The Keypad
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page 8-49
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
To De-activate Password Protection
If you try to change the value of a parameter with password protection activated, the PASSWORD screen is
displayed for you to enter the current password. If you enter the password correctly password protection is
temporarily de-activated.
To Re-activate Password Protection
Re-activate an existing password by pressing the E key repeatedly until the PASSWORD LOCKED screen
is displayed.
To Remove Password Protection (default status)
Navigate to the PASSWORD parameter and enter the current password. Press the E key. Reset the
password to 0000. Password protection is now removed.
You can check that password protection has been removed by repeatedly pressing the E key until the
Welcome screen is displayed. Pressing the E key again will NOT display the PASSWORD LOCKED
screen.
Note Perform a SAVE CONFIG if you need “no password” to be saved on power-down.