Parker Hannifin S.p.A. - S.B.C. Division HPD N User’s Manual
2
WARNING
HIGH VOLTAGE !
Certain circuits in the
HPD drive carry dangerously high voltages that could cause serious
personal injury or death.
Do not attempt to service any parts of the drive when it is connected to the power
supply.
If you need to access internal parts, before working on the drive allow at least 15 minutes
after power-down to allow the DC bus capacitors to discharge. It is the User’s responsibility
to make sure that the installation is executed in accordance with established industrial health
and safety standards.
In relation to the interpretation of standards, note that the drive is considered as a component
and not as a machine.
Any tampering or unauthorised modification of the drive will invalidate the guarantee
immediately. Guarantee cover is otherwise provided for 1 (one) year.
This instruction manual is applicable to the standard version of the drive.
Parker Hannifin S.p.A. - S.B.C. Division declines all liability for any whatsoever form of
damage caused by inappropriate use of the drive.
Training courses can be supplied by Parker Hannifin S.p.A. - S.B.C. Division on request.
Cod 0907131040
Installation and maintenance of the drive and connected
equipment must be performed exclusively by qualified and
trained personnel with basic skills in electronics.
Commissioning of the drive must performed exclusively by
qualified and trained personnel with advanced skills in
electronics and drive technology.
The quoted performance of the HPD drive is guaranteed only
when used with series MB synchronous motors
manufactured by Parker Hannifin S.p.A. - S.B.C. Division
To Next Page
Loading...
