Parker K Series User Manual

16 - PVD 3674_GB_K Series_CE-November 2016.Docx
3.1.5. Current limitation at stall conditions (i.e. speed < 3 rpm)
Recommended reduced current at speed < 3 rpm:
00
*0.7*
2
1
III
reduced

Warning: The current must be limited to the prescribed values. If the
nominal torque has to be maintained at stop or low speed (< 3 rpm),
imperatively limit the current to 70% of I
0
(permanent current at low
speed), in order to avoid an excessive overheating of the motor.
Please refer to the drive technical documentation for any further
information and to choose functions to program the drive.
3.1.6. Peak current limitations
It is possible to use the K Series Kit with a current higher than the permanent current.
But, to avoid any overheating, the following rules must be respected.
1) The peak currents and peak torques given in the data sheet must never be
exceeded
2) The thermal equivalent torque must be respected (§3.1.3)
3) If 1) and 2) are respected (it can limit the peak current value or duration), the
peak current duration (tp) must be limited, in addition, accordingly to the
following table (Io is the permanent current at low speed):
Ipeak/In
Ip/Io =2
Ip/Io = 3
Ip/Io =4
Ip/Io >5
K032
tp<0.8 s
tp<0.3s
tp<0.15s
tp<0.1s
K044
K064
tp<1.5s
tp<0.6s
tp<0.3s
tp<0.2s
K089
K178
tp<3s
tp<1.5s
not allowed
The peak current duration is calculated for a temperature rise of 3°C
Consult us for more demanding applications.
0
1
2
3
4
0 5 10 15 20 25
Peak current/Low speed
current
Time
I/Io
tp
tc

Parker K Series Specifications

General

Brand	Parker
Model	K Series
Category	Servo Drives
Language	English