41 - PVD 3674_GB_K Series_CE-November 2016.Docx
Activator #7074
Loctite #609
Final Assembly:
Rotor magnets to be in line with stator laminations and concentric to stator lamination
I.D. within 0.127 mm MAX.
Caution : Rotor assembly magnets are powerful and fragile!
Do not place near magnetically sensitive material.
Do not place near other ferromagnetic materials such as iron, steel and
nickel alloys. Strong uncontrolled attraction may damage magnets on
contact.
Caution : When assembling the rotor into the stator, high radial forces
will be experienced, witch can cause the magnets to “crash” into the
stator and be damaged and / or cause bodily injury!
The following precautions should be taken:
Wrap the rotor with a thin (0.12 mm thick) Mylar sleeve which fill the air gap
between the rotor and stator during assembly and can be easily removed when
assembly is complete.
Support the rotor and stator assemblies in a fixturing arrangement which will
prevent radial motion while the two assemblies are being mated.
To Next Page
Loading...
