Parker K Series - Resolver Cables and Connectors; Resolver Setting Procedure

54 - PVD 3674_GB_K Series_CE-November 2016.Docx
3.7.2.4. Cables and connectors associated to the resolver
To connect the motor with a connector M23 to PARKER drive : AC890, COMPAX3 or
SLVD, you can use complete cable with part number on the tabs below.
The "xxx" in the part number must be replaced by the length in meter.
Ex : for 20m cable, "xxx" = 020.
Feedback
Sensor
Cable reference
for AC890
Cable reference
for COMPAX3
Cable reference
for SLVD
Resolver
CS4UA1F1R0xxx
CC3UA1F1R0xxx
CS5UA1F1R0xxx
For other drive, you can assembly cable and plug by soldering with part number on
the tab below:
Feedback Sensor
Cable reference
Plug reference
Resolver
6537P0047
220065R4621
3.7.2.5. Resolver setting
During the setting procedure, it is strictly necessary to respect the 3 following
conditions:
- The rotor must be able to rotate freely. The maximum friction torque on the
rotor must not exceed 1% of the motor permanent torque.
- The cooling circuit has to be in use.
- The operator must be able to reach the resolver stator and to manually turn it
and lock it (access to the locking screws).
Look at the drive instruction manual for the setting procedure details.