PAGE 31
31 Percent Output PorA 0 = None
0
Relay Actuation 1 = Based upon
proportional Output 1
On when process is
above PoAP
2 = Based upon proportional
Output 1
On when process is
below PoAP
3 = Based upon proportional
Output 2
On when process is
above PoAP
4 = Based upon proportional
Output 2
On when prcess is
below PoAP
32 Percent Output PoAP 0 to 100 percent
95
Actuation Point The relay assigned to
"Special Actuation 1"
will activate per PorA
at the percentage output
specified by PoAP.
Extended Features Software Options (EB)
33 Setpoint SPrr 0 to 100°/Units per minute
0.0
Ramp Rate 0 = not used
Communication Parameters 33-35 are optional
34 Communications CCon 0 = Off
0
Configuration 1 = Monitor Mode (Read Only)
2 = Normal Mode (Read & Write)
3 = Total Access with Limit Checking
4 = Total Access without
Limit Checking
35 Communications CbS 1 = 300 bit rate
6
Bit Rate 2 = 600 bit rate
3 = 1200 bit rate
4 = 2400 bit rate
5 = 4800 bit rate
6 = 9600 bit rate
36 Communications CAd 0 to 99
0
STEP DESCRIPTION DISPLAY AVAILABLE FACTORY YOUR
CODE SETTINGS SETTING SETTING
To Next Page
Loading...
