Additional Information 34
SmartNode 200 User Manual 5 • Initial Configuration
Optionally, you may execute the Wizard that matches your application online, and import the generated .cfg
config into the SmartNode device.
In addition to that the Knowledgebase provides configuration file templates that may fit your application.
Note If your application is unique and not covered by any of Patton’s configura-
tion templates, you can manually configure the SmartNode instead of load-
ing a configuration file template. In that case, refer to the Trinity Command
Line Reference Guide for information on configuring the SmartNode device.
In this example we assume the TFTP server on the host with the IP address 172.16.1.11 and the configuration
named SN.cfg in the root directory of the TFTP server.
172.16.1.99(if-ip)[WAN]#copy tftp://172.16.1.11/sn.cfg startup-config
172.16.1.99(if-ip)[WAN]#
After the SmartNode device has been rebooted the new startup configuration will be activated.
172.16.1.99(if-ip)[WAN]#reload
Press 'yes' to restart, 'no' to cancel :yes
The system is going down NOW
Additional Information
For detailed information about configuring and operating guidance, set-up procedures, and troubleshooting,
refer to the Trinity Command Line Reference Guide
available online at www.patton.com/manuals.
To Next Page
Loading...