© PCE Instruments
14
7.2 Outdoor temperature
Make outdoor temperature settings as follows:
1) Touch the OUTDOOR TEMPERATURE section, the + and – buttons will flash. Touch
the + or – button to shift the display between outdoor temperature, wind chill and dew
point.
2) Touch the OUTDOOR TEMPERATURE section again, the + and – buttons will flash.
Touch the + or – button to shift the display unit between °C and °F.
3) Touch the OUTDOOR TEMPERATURE section the third time to set the outdoor
temperature high alarm function. The +, ON/OFF and – buttons will flash, the HI AL icon
will light up. Touch the+ or – button to change the value, hold the+ or – button for 3 s to
change the number in larger steps. Touch the ON/OFF button to turn the alarm on or
off (if alarm is enabled, the speaker icon will be turned on, indicating the alarm function
has been enabled).
4) Touch the OUTDOOR TEMPERATURE section the fourth time to set the outdoor
temperature low alarm function. The +, ON/OFF and – buttons will flash, the LO AL icon
will light up. Touch the + or – button to change the value, touch and hold the + or –
button for 3 s to change the number in larger steps. Touch the ON/OFF button to turn
the alarm on or off (if alarm is enabled, the speaker icon will be turned on).
5) Touch the OUTDOOR TEMPERATURE section the fifth time to display the maximum
outdoor temperature record. The recorded maximum value will flash, the MAX icon will
light up. After holding the flashing MAX value for 3 s, the maximum value will be reset
to current reading.
6) Touch the OUTDOOR TEMPERATURE section the sixth time to display the minimum
outdoor temperature record. The recorded minimum value will flash, the MIN icon will
light up. After holding the minimum value for 3 s, the minimum value will be reset to
current reading.
To Next Page
Loading...
Need help?
General