© PCE Instruments
15
7.3 Indoor humidity
Make indoor humidity settings as follows:
1) Touch the INDOOR HUMIDITY section to set the indoor humidity high alarm function.
The +, ON/OFF and – buttons will flash, the HI AL icon will light up. Touch the + or –
button to change the value, touch and hold the + or – button for 3 s to change the
number in larger steps. Touch the ON/OFF button to turn the alarm on or off (if alarm
is enabled, the speaker icon will be turned on, indicating the alarm function has been
enabled).
2) Touch the INDOOR HUMIDITY section again to set the indoor humidity low alarm
function. The +, ON/OFF and – buttons will flash, the LO AL icon will light up. Touch
the + or – button to change the value, touch and hold the+ or – button for 3 s to change
the number in larger steps. Touch the ON/OFF button to turn the alarm on or off (if
alarm is enabled, the speaker icon will be turned on, indicating the alarm function has
been enabled).
3) Touch the INDOOR HUMIDITY section the third time to display the maximum indoor
humidity record. The recorded maximum value will flash and the MAX icon will light up.
After holding the maximum value for 3 s, the maximum value will be reset to current
reading.
4) Touch the INDOOR HUMIDITY section the fourth time to display the minimum indoor
humidity record. The recorded minimum value will flash and the MIN icon will light up.
After holding the minimum value for 3 s, the minimum value will be reset to current
reading.
7.4 Outdoor humidity
Procedures and settings are similar to indoor humidity.
To Next Page
Loading...
Need help?
General