© PCE Instruments
16
7.5 Wind speed/direction
Make wind settings as follows:
1) Touch the WIND SPEED section, the + and – buttons will flash. Touch the + or – button
to shift the display between average wind speed and gust speed.
2) Touch the WIND SPEED section again, the + and – buttons will flash. Touch the + or –
button to select the wind speed unit: km/h, mph, m/s, knots or bft.
3) Touch the WIND SPEED section the third time to set the high alarm function, the +,
ON/OFF and – button will flash, the HI AL icon will light up. Touch the + or – button to
change the value, touch and hold the+ or – button for 3 s to change the number in larger
steps. Touch the ON/OFF button to turn the alarm on or off (if alarm is enabled, the
speaker icon will be turned on, indicating the alarm function has been enabled).
4) Touch the Wind SPEED section the fourth time to set the wind direction alarm function,
the wind direction arrow will start flashing. Touch + or – to select the desired alarm for
the wind direction. Press ON/OFF to enable or disable the wind direction alarm.
5) Touch the Wind SPEED section the fifth time to display the maximum wind speed
record. The recorded maximum value will flash and the MAX icon will light up. After
holding the maximum value for 3 s, the maximum value will be reset to current reading.
To Next Page
Loading...
Need help?
General