© PCE Instruments
21
7.12 Memory
Touch the MEMORY section to activate history data toggle display. The + and – buttons will flash.
Press – to toggle forward to see earlier weather history data together with their time stamp. Press
+ to see later history weather data. When history data are displayed, the corresponding time will
be displayed in the time section (History data saving interval can only be changed using the PC
software that can be downloaded for this product. The default history data saving time interval is
30 minutes).
Touch the MEMORY section again to trigger the memory clear procedure: the word “CLEAR” as
well as the full memory icon will flash. Touch and hold the memory full icon for 3 seconds to clear
the memory.
8 Maintenance
1. Clean the rain gauge once every 3 months. Rotate the funnel counter-clockwise, lift it
to expose the inside of the rain gauge and clean it with a damp cloth. Remove any dirt,
debris and insects. If bug infestation is an issue, spray the rain gauge lightly with
insecticide.
2. Clean the solar panel every 3 months with a damp cloth.
3. Replace the batteries every 1 to 2 years. If left in too long, the batteries may leak due
to environmental challenges. In harsh environments, inspect the batteries every 3
months (when cleaning the solar panel).
4. When replacing the batteries, apply a corrosion preventive compound on the battery
terminals, available at most hardware stores.
5. In snowy environments, spray the top of the weather station with anti-icing / silicon
spray to prevent snow build up.
9 PC connection
As an important feature in addition to displaying data on the touch screen, the weather station
allows the read-out of all measured and displayed time and weather data in the form of complete
history data sets on a PC.
9.1 Data storage
For a comprehensive weather history, the display allows the internal storage of up to 4080
complete sets of weather data with time and date. The display will lose all weather data when the
power supply is interrupted. In case the memory capacity of the weather station is exhausted, the
oldest data sets stored will be overwritten by the new ones entered.
9.2 Data recall
Certain weather data or set values can only be read out, processed and displayed by means of a
PC. Also, setting the storage interval from 5 minutes to 240 minutes for the storage of data sets
can only be performed by means of a PC.
To Next Page
Loading...
Need help?
General