© PCE Instruments
17
7.6 Rain
Make rain settings as follows:
1) Touch the RAIN section, the + and – buttons will flash. Touch the + or – button to shift
the display between 1 h, 24 h, week, month and total rain.
2) Touch the RAIN section again. The + and – buttons will flash. Touch the + or – button
to select the rainfall unit: mm or inch.
3) Touch the RAIN section the third time to set the high alarm function. The +, ON/OFF
and – buttons will flash and the HI AL icon will light up. Touch the + or – button to
change the value, hold the + or – button for 3 s to change the number in larger steps.
Touch the ON/OFF button to turn the alarm on or off (if alarm is enabled, the speaker
icon will be turned on, indicating the alarm function has been enabled).
4) Touch the RAIN section the fourth time to display the current maximum rainfall record.
Touch the flashing MAX value for 3 s to reset the maximum rainfall value to current
value.
5) Touch the RAIN section the fifth time to reset the rainfall value to 0 by holding the
flashing reading for 3 s. Then 1 h, 24 h, week, month and total rain will be reset to 0.
To Next Page
Loading...
Need help?
General