Microdrive Series Instruction Manual
4201-109 Rev I
4201-003 Rev A
Page 10 of 12
Figure and Tables
Figure 1.1a The Microdrive-3 (UD3) 17
Figure 1.1b The Microdrive-i (UDi) 17
Figure 1.2a The Microdrive-3 (UD3) Block Diagram 18
Figure 1.2b The Microdrive-i (UDi) Block Diagram 19
Figure 1.3a Microdrive-3 (UD3) Mounting Details 22
Figure 1.3b Microdrive-i (UDi 90250) Cabinet Floor and Wall Mounting Details 23
Figure 1.3c Microdrive-i (UDi 300660) Cabinet Floor and Wall Mounting Details 24
Figure 1.3d Microdrive-i (UDi 90250) Baseplate Wall Mounting Details 25
Figure 1.4a Microdrive-3 (UD3) Recommended Power Wiring Instructions 26
Figure 1.4b Microdrive-i (UDi) Recommended Power Wiring Instructions 27
Figure 1.5 The Control Panel 28
Figure 1.6 Standard Configuration of the Control Terminals 30
Figure 1.7 Microdrive Problem Solving Chart 34
Figure 2.1 Block Diagram: Microdrive Programmable Configurations 41
Figure 2.2 The Microdrive Control Inputs and Outputs 42
Table 1.1 Display Screen Messages - Short Menus 31
Table 2.1.1 Display Screen Messages - Full Menus 43
Table 2.1.1 Display Screen Messages - Full Menus 44
Table 2.1.2 Display Screen Messages - Full Menu Modes 45
Table 2.1.2 Display Screen Messages - Full Menu Modes 46
APPENDIX 3: LOCAL KEYBOARD OPERATION 98
APPENDIX 4: USING THE MICRODRIVE AS A PROCESS CONTROLLER 99
4A: General Notes 99
4B: APPLICATION EXAMPLE - TACHO FEEDBACK 99
4C: APPLICATION EXAMPLE -CONSTANT PRESSURE PUMPING 100
4D: APPLICATION EXAMPLE -CONSTANT PRESSURE PUMPING WITH AUTOMATIC
STOP/START CONTROL 102
APPENDIX 5: MICRODRIVE-3 OPERATION FROM NON-STANDARD SUPPLIES 105
5A: UD3 DC SUPPLY 105
5B: UD3 SINGLE PHASE AC SUPPLY 105
5C: UD3 220-480V, THREE PHASE SPECIAL OPTIONS 105
5D: UDi DC SUPPLY 106
5E: UDi SINGLE PHASE AC SUPPLY 106
APPENDIX 5: MICRODRIVE-I OPERATION FROM NON-STANDARD SUPPLIES 106
APPENDIX 6: TORQUE CONTROL USING THE MICRODRIVE CURRENT LIMIT 107
6A: GENERAL NOTES 107
6B: APPLICATION EXAMPLE -CONSTANT TENSION WINDER 108
INDEX 109
To Next Page
Loading...
Need help?
General
