Failure to properly lift the machine may result in damage to the
machine, serious personal injury or death.
Important:
If using a chain hoist or forklift, check that the chain or forks bear
against machine mainframe only. Do not apply any undue pressure
to other machine parts, especially electrical cords or conduit.
Leveling the Machine
Note: A bubble-type level (4 ft. minimum ) is useful when leveling the machine.
Note: Replace "shipping" feet with leg levelers before leveling the machine.
1. Refer to machine floor plan drawing for machine height.
2. Extend all leg levelers.
3. Adjust the leg levelers, as necessary, to re-position the machine until level.
4. Bolt the machine to the floor ro prevent movement.
CE35-T Case Erector Operations Manual
3/2/2010 M-CE35T-2c Horiz Mag
24
noitallatsnI
Fig. 14 Leveling legs
Leveling Legs
To Next Page
Loading...