Need help?Do you have a question about the Pego ECP202 EXPERT + BASE Series and is the answer not in the manual?
General| Brand | Pego |
|---|---|
| Model | ECP202 EXPERT + BASE Series |
| Category | Control Panel |
| Language | English |
Details on product identification codes and their associated functions.
Physical dimensions and measurements of the ECP202 EXPERT + BASE unit.
Information found on the unit's identification plate.
Crucial guidelines for safe and correct installation of the ECP202 EXPERT + BASE unit.
Components included in the ECP202 EXPERT + BASE assembly kit.
Step-by-step instructions for physically installing the ECP202 EXPERT + BASE unit.
Electrical connection guidelines and final panel assembly.
Conditions and limitations of the ECP202 EXPERT + BASE product warranty.
Identification and layout of the controller's main interface elements.
Description of the function of each button on the front keypad.
Explanation of the meaning of various LED indicators and display symbols.
Overview of the two programming levels (User and Installer).
Explanation of symbols used for navigation and control.
Procedure for viewing and adjusting the temperature setpoint.
Steps to access and modify user-level programming parameters.
Table detailing user-configurable parameters and their default values.
Steps to access and modify installer-level programming parameters.
Table detailing installer-configurable parameters and their default values.
Details on parameters like dFd, Ad, SEr, Bdr, Prt, Ald, C1, CAL, CE1, CE2, doC, tdo, Fst, Fd, LSE, HSE.
Configuration parameters for auxiliary relays (AU1, AU2) and inputs (In1, In2, bEE).
Procedure for powering up the controller and initial system behavior.
Conditions governing compressor or heat output activation/deactivation.
How to initiate and terminate defrost cycles manually.
Configuration for defrost using heaters with temperature control.
Setup for defrosting using the hot gas method.
Configuration and operation of the pump-down function.
How to activate and use the password protection feature.
Instructions for connecting the controller to the TeleNET monitoring system.
Guidelines for configuring the RS485 Modbus-RTU network.
Formal declaration of the product's compliance with relevant European Union directives.
Schematic illustrating the electrical connections for the ECP202 EXPERT + BASE unit.
Example wiring for direct control of functions using the controller's outputs.
Example wiring for mixed control of condensing unit and other outputs.
To Next Page
