8-66 Command Reference
:MEASure [:VOLT] :PTPeak?
[8 (@«1|2»)].
Peak-to-Peak Voltage
This command measures the peak-to-peak voltage on either main input channel.
Parameters:
(@«1|2») is the measurement channel
(@1) means input A
(@2) means input B
Complies with standards: SCPI 1991.0, confirmed.
:MEASure [:VOLT] :RATio?
[8(@1|@2),(@1|@2)]
Peak-to-Peak Voltage Ratio in dB
This command measures the peak-to-peak voltage ratio in dB between the se-
lected channels.
Parameters:
(@«1|2») is the measurement channel
(@1) means input A
(@2) means input B
To Next Page
Loading...
