Command Reference 8-67
:MEASure [:VOLT] :PSLEwrate?
[8(@1|@2)]
Positive Slew Rate
This command measures the positive slew rate in V/s on either main input channel.
Parameters:
(@«1|2») is the measurement channel
(@1) means input A
(@2) means input B
:MEASure [:VOLT] :NSLEwrate?
[8(@1|@2)]
Negative Slew Rate
This command measures the negative slew rate in V/s on either main input chan-
nel.
Parameters:
(@«1|2») is the measurement channel
(@1) means input A
(@2) means input B
To Next Page
Loading...
