Pentair Fleck 4600-MECH - Manual regeneration

Installer Manual Fleck 4600 - MECH - Operation
56 / 88 Ref. MKT-IM-027 / B - 01.06.2018
8.2. Recommendations
• Use only regeneration salts designed for water softening upon regulation EN973;
• for optimal system operation, the use of clean salt and impurities free is recommended (for
example salt pellets);
• the sanitizing process (both with liquid and electrochlorination) may introduce chlorine
compounds which may reduce the lifetime of the ion exchange resins. Refer to the technical
guides for resins in common use, providing necessary checks on the system.
8.3. Manual regeneration
Mandatory
The controller must be in service in order to enable this procedure.
8.3.1. Manual immediate regeneration
8.3.2. To advance regeneration cycles
8.4. Operation during a power failure
• The valve stops in its actual position during power failure.
No. Operation
A
Turn the control knob (3) until appears in the window (2) and the red light (1) lights.
No. Operation
A Turn the control knob (3) until the desired cycle appears in the window (2).