Pentair HAFFMANS c-DGM - Page 31

HAFFMANS c-DGM/i-DGM
c-DGM/i-DGM Page 31 of 78
If the RFID system (optional) is active, you will be asked to identify
yourself (User ID). To do so, hold the operator key against the front
of the instrument (see fig. 6.1). Next, give the measurement location
by holding the front of the DGM against the location key. This key is
fitted in a convenient place at the measurement location. The
measurement starts automatically after both the user and the
location have been identified.
There is a bar at the bottom of the display that gives the actual
measurement values (see figs. 6.2 and 6.3).
Fig. 6.1 Identification
BUSY MEASURING...
CO
2
PROGRESS:
T: 22.2 P: 0.00 O
2
: 90
Fig. 6.2 c-DGM display during a measurement
BUSY MEASURING...
PROGRESS:
001 T: 22.2 P: 12:00 AM
Fig. 6.3 i-DGM display during a measurement
The bar at the top indicates the battery status.
If this bar flashes, you can only carry out a few measurements with the DGM before you must
charge the battery.
Battery status
Temperature, pressure and O
2
Battery status
Progress of the measurement
Temperature and pressure
Number of the measurement
Progress of the measurement