HAFFMANS c-DGM/i-DGM
c-DGM/i-DGM Page 39 of 78
6.3 Reading the measurement results
Procedure:
1. Press “Enter” for approximately 3 seconds.
The input menu is shown.
2. Press the “Enter” button.
The main menu is displayed.
3. Use the Down arrow button to select “Logbook” in the main menu and press “Enter”.
4. Select “Results” in the logbook menu and press the “Enter” button.
5. Now you can read the measurement results.
To select a different measurement, you must page up or down through the measurement
numbers.
6. Press “Enter” to return to the main menu.
6.4 Erasing measurement results
Procedure:
1. Press “Enter” for approximately 3 seconds.
The input menu is shown.
2. Press “Enter” again.
The main menu is displayed.
3. Use the Down arrow button to select “Logbook” in the main menu and press “Enter”.
4. Select “Clear results” or “Clear last result” in the “Logbook” menu and press “Enter”.
5. This automatically takes you back to the main menu.
6.5 Product choice
The DGM allows you to set product-specific settings (see 5.5).
The predefined products can be selected from the “Product choice” menu before a
measurement is carried out or they can be programmed in the key for the place ID.
The following steps take you to the “Product choice” menu:
1. Press “Enter” until the Haffmans logo appears.
2. Press “Enter" again.
This takes you to the main menu.
3. Use the arrow buttons to select the “Product choice” menu and then press “Enter” to
open the menu.
4. Use the arrow buttons to select one of the products and press “Enter” to confirm your
choice and return to the main menu.
To Next Page
Loading...