Spa Pump On/Off: Tap this button to switch the spa filter pump on or off and to activate the heater; if a
heater source is selected. See Spa Heater button. Note: The heater will activate when the pool pump is on
and the temperature Set Point is above or equal to the current temperature reading.
Spa Temperature: Displays the current spa water temperature in Fahrenheit.
Heating Set Point: Use the Up/Down button to increase or decrease the spa water set point temperature.
Spa Heat Mode Button: Tap this button access the Select Heat Mode screen. Heat Mode options are Off, Gas, Solar, Solar Preferred, Heat Pump (Preferred),
UltraTemp Preferred, Hybrid Preferred. Select OFF for no heater installed. When the heater is turned on the heater will activate when the pool pump is on
and the temperature Set Point is above the current temperature reading. Note: Heaters are configured from Settings > Advanced System Configuration >
Installation Setup > Heaters.
Spa
Spa Manual Heat ON/OFF: If Spa Manual Heat is ON and the Spa pump button (or from the Spa-Side remote, or Wireless Controller) is turned on, the pump will turn on and the heater will
begin to heat the spa (even if the heater is set to OFF). This feature allows you to program the pool pump to filter daily with the heater set to off, and then be ready to heat whenever the
Spa button is pressed. Heat Enabled is switched on by default. See Settings > Advanced System Configuration > Installation Setup > Spa Body Configuration >Spa Settings.
Also see, Manual OP Priority: This feature allow for a circuit to be manually switched OFF and switched ON within a scheduled program, the circuit will continue to run for a maximum of 12 hours
or whatever that circuit Egg Timer is set to, after which the scheduled program will resume. This feature will turn off any scheduled program to allow manual pump override. Default
is OFF. See Settings > General > Manual Operation Priority.
Tap the Home screen Spa icon to display the Spa Pump control settings screen. From this screen tap the Spa Pump button to activate the Spa heat source. A Blue badge displayed on
the Spa icon indicates the Pool/Spa pump button has been manually turned on. The Blue badge displays until the pump button is turned off. The badge
displays the current pool water temperature. If there is a heat source active, a flame icon is displayed with the pool water set point temperatur source.
Spa Badge Icons: A Flame icon indicates that the heat source has been called for. A Snow Flake icon indicates the UltraTemp Heat Pump or Solar Heat
(if enabled) is in cooling mode. A Sun icon indicates solar heat is active. Select the heat source from the Select Heat Source screen.
To Next Page
Loading...
Need help?
General
