PEP Modular Computers VMP2 - Page 96

NetBootLoader VMP2
Page 5 - 22 © 2002 PEP Modular Computers GmbH ID 24855, Rev. 02
SYNTAX:
logout
DESCRIPTION: A remote telnet session will be terminated with the command
“logout”. No application is loaded and started if the session is
terminated with “logout”. The NetBootLoader waits for a new session
to be initiated or for a command entry from the serial console.
LS
FUNCTION: Display listing of the current ftp server directory
SYNTAX:
ls
DESCRIPTION: To display a listing of the current ftp server directory the command
“ls” is used. This command downloads the listing to the data buffer
and then the listing is displayed. Any previously loaded image in the
data buffer is overwritten. If an attempt is then made to program the
FLASH after the “ls” command has been issued it will fail.
MD
FUNCTION: Display visible memory
SYNTAX:
md [<adr>]
where:
md command
<adr> parameter: value: hexadecimal
starting address of a visible memory area
DESCRIPTION: To display a visible memory area the command “md” is used. The
first time the command “md” is issued, visible memory contents
starting at the address 0x0 are displayed if no “<adr>” parameter is
used. If issued again without the “<adr>” parameter, the display starts
with the end address of the previous display. Data is displayed as
hexadecimal 32-bit words and as ASCII dump.
LOGOUT
StockCheck.com