PEP Modular Computers VMP2 - Page 99

VMP2 NetBootLoader
ID 24855, Rev. 02 © 2002 PEP Modular Computers GmbH Page 5 - 25
PCI
FUNCTION: Display PCI information
SYNTAX:
pci
DESCRIPTION: The command “pci” is used to display detailed information on all
detected PCI devices. The bus number, device number, function
number, vendor, and device ID’s are displayed together with the
configured base addresses and the assigned IRQ number.
PF
FUNCTION: Set or display the serial port parameters (format)
SYNTAX:
pf [<port> [<baud>][/[<bitschar>]
…[/[<parity>][/<stops>]]]]
where:
pf command
<port> parameter: string: “term” or “ser0”
defines serial port to be configured
<baud> parameter: value: numeric: “50, 75, 110, 134.5,
150, 300, 600, 1200, 1800, 2000, 2400, 3600,
4800, 7200, 9600, 19200, 38400, 115200”
defines the baud rate for the port
<bitschar> parameter: value: numeric: “7” or “8”
defines the number of bits per character
<parity> parameter: string: “n” (none), “o” (odd), “e” (even)
defines parity to be used
<stops> parameter: value: number: “1”, “2”
defines number of stop bits
StockCheck.com