http://www.pepwave.com 47 Copyright © 5/23/16 Pepwave
User Manual
PEPWAVE AP Series
To set up PepVPN, first give your site a local PepVPN ID. To modify an existing local ID, click .
Once you’ve specified a local ID, click the New Profile button to configure PepVPN.
Enable Check this box to enable PepVPN.
Enter a name to represent this profile. The name can be any combination of
Name alphanumeric characters (0-9, A-Z, a-z), underscores (_), dashes (-), and/or nonleading/trailing
spaces ( ).
Encryption By default, VPN traffic is encrypted with 256-bit AES. If Off is selected on both sides of a VPN
connection, no encryption will be applied.
Remote ID To allow your access point to establish a VPN connection with a specific remote peer using a
unique identifying number, enter the peer’s ID or serial number here.
Select By Remote ID Only or Preshared Key to specify the method your access point
Authentication will use to authenticate peers. When selecting By Remote ID Only, be sure to enter a unique
peer ID number in the Remote ID field.
To Next Page
Loading...
