What to do if the gripper contains no sample when entering the furnace in PerkinElmer Measuring Instruments?
If the gripper contains no sample when entering the furnace, it means there was no sample pan at the reserved position on the sample tray. Place a sample on position 0 of the sample tray.
General| Type | Differential Scanning Calorimeter |
|---|---|
| Temperature Resolution | 0.01 °C |
| Temperature Accuracy | ±0.1 °C |
| Software | Pyris Software |
| Calorimetric Sensitivity | 0.2 μW |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Heating Rate | 0.1 °C/min to 100 °C/min |
| Cooling Rate | 0.1 °C/min to 100 °C/min |
| Detector | Heat Flux |
| Atmosphere | Inert, Oxidizing, Reducing |
| Sample Pan Type | Aluminum, Platinum |
| Data Sampling Rate | Up to 100 points per second |
To Next Page