KENR9126 105
Troubleshooting Section
Results:
•
OK – There is a problem with the transmission.
Repair: Make t
he necessary repairs. Verify that
the problem is resolved.
STOP.
i04018233
E119 Low Fue
l Level
Conditions Which Generate This Code:
This event
code will only be generated if the sensor
for the fuel level is installed and correctly wired to the
ECM. The feature must be enabled in the customer
programma
ble parameters on the electronic service
tool.
The fuel l
evel is below the trip point. Refer to
Troubleshooting, “Event Codes” for the trip points.
System R
esponse:
The Electronic Control Module (ECM) will log the
event.
Possible Performance Effect:
•
There are no performance effects.
Troubl
eshooting:
Add fuel to the fuel tank. Refer to the literature that
is pro
vided by the OEM of the vessel for the correct
procedure.
Resul
ts:
•
OK – STOP.
i040
18234
E179 Alternator Not Charging
Con
ditions Which Generate This Code:
The Electronic Control Module (ECM) detects that the
al
ternator is not charging the batteries. Information
on default settings and ranges for these event codes
can be found in troubleshooting with an event code
Tr
oubleshooting, “Event Codes”.
System Response:
The Electronic Control Module (ECM) will log the
code.
Possible Pe rformance Effect:
•
There are no p
erformance effects.
Troubleshooting:
Check the Alternator Relay
Check the re
lay attached to the alternator which is
driven by the alternator output voltage.
Expected R
esult:
The alternator is not driving the relay.
Results:
•
OK – The al
ternator is driving the relay.
Repair: Make the necessary repairs. Verify that
the repai
r eliminates the problem.
STOP.
i040166
11
E194 High Exhaust
Temper
ature
Conditions Which Gen erate This Code:
This e
vent code will only be generated if the sensor
for the exhaust gas temperature is installed and
correctly wired to the ECM. The feature must be
enabl
ed in the customer programmable parameters
on the electronic service tool.
The e
xhaust gas temperature has exceeded the trip
point. Refer to Troubleshooting, “Event Codes” for
the trip point.
System Response:
If e
quipped, the warning lamp may come on and the
event code will be logged.
Pos
sible Performance Effect:
None
Test Step 1. Determine the Operating
Conditions
D
etermine if the engine was under heavy load or the
engine is operating at a high altitude.
To Next Page
Loading...
