KENR9126 29
Troubleshooting Section
5. Remove the removal tool from the face of the
connector (3).
Note: If a terminal must be replaced, part number
28170085 must
be used.
Terminal Insertion
1. Push the terminal into the rear of the connector (3)
until the terminal engages with the locking device.
2. Gentlypullonthewireinordertomakesurethat
the terminal is retained by the locking device.
3. Install the two terminal position assurance
components (2) into the sides of the connector (3).
4. Connect the connector to the ECM. Refer to
Disassembly and Assembly, “Electronic Control
Module - Re
move and Install”.
To Next Page
Loading...
