101
The Menu Interface
9.10 Lines Menu
This option allows the administrator to configure all of the
parameters for any of the ports. The parameters accessible
are exactly the same as those in the
Port Setup Menu
, but
from these menus you can configure a set of parameters for
all of the ports. Selecting this option brings up the
Lines
pop-up menu as shown below.
** Administrator ** ADMINISTRATION MENU REMOTE-ADMIN
access Remote System Access (PPP).
change Change login and/or admin password.
gateway Examine/modify gateway table.
host Examine/modify host table.
kill === Lines ===connections on serial line.
line | Access |configuration organised by line.
port | Flow ctrl |configuration organised by port.
quit | Hardware | connections menu.
reboot | Network |rver.
server | Options |odify Server parameters.
stats | Terminal |erver statistics.
trap =============odify SNMP Trap parameters.
________________________________________________________________________________
Figure 41: Administration Menu - LInes pop-up menu.
Each of the options displayed in the pop-up menu brings up
another menu. These are detailed in the following sections.
Access
The
Access
section shows and allows changes to the name,
access, authentication and mode fields. These fields are
described in
The Port Menu - Access Section
above.
** Administrator ** ACCESS MENU REMOTE-ADMIN
TTY Name Access Authentication Mode
1 [mark ] [Dynamic] [Host ] [Telnet]
2 [alan ] [Dynamic] [Host ] [Telnet]
Figure 42: Lines - Access Menu.
To Next Page
Loading...
