Perle IOLAN + Rack - Client Login; Remote Site Devices Screen

36
IOLAN
+
- User and Administration Guide
** Administrator ** REMOTE SITE DEVICES SCREEN REMOTE-ADMIN
Type [port3 ]
IP Addresses
Src Addr [ ]
Dst Addr [ ]
Modem
Config [ate0s0=1&w ]
Dial Comm [ ]
Hang Up [ ]
PPP Configuration Dialer Configuration
Restart timer [1 ] Dial Timeout [40]
Max Retries [5 ] Dial Retries [2 ]
Inactivity [0 ]
________________________________________________________________________________
Figure 19: Remote Site Devices Screen.
You will now need to kill this port (from the Administration
Menu
or CLI) to activate the changes and configure the modem.
The configuration string will be sent to the modem after each
call, keeping the modem in sync with IOLAN+.
4.4 Client Login
When the caller connects, you may want to send out a
welcome message of some sort (see MOTD tip below). After
the user gets this message, you want him/her to enter a login
and password then connect to the Host for a shell account.
Or, if it is a PPP user, they will simply start sending PPP
packets at the login prompt (e.g. Windows
®
95/98) and use
PAP for authentication. Optionally, the dial-in user can
place a P, S or C (all caps) in front of the user name at the
Login prompt (this starts the corresponding protocol after
successful authentication).
Welcome to the Internet site
login: Cflint
password:
Host authentication succeeded.