47
Dial-out Modem Ports Setup
Dial-Out Modem Ports Setup 6
Dial-out ports can be just a simple Unix outbound
cu
call
or IOLAN+ can act as a dial-out router to facilitate Internet
PPP requests.
As a dial-out router IOLAN+ automatically establishes a
PPP/SLIP/CSLIP link to that site. Then drops the call after a
preset period of inactivity. This dial-on-demand feature is
automatic. IOLAN+ will place the call when local TCP/IP
traffic needs to be routed to a configured remote site.
If not using dial-out routing, you will need a COMPORT
redirector such as
ioland
. The Perle CD has the ioland
utility if you are using Unix. Please load the appropriate
binary onto your system. If you can not find the correct
binary, please compile the
ioland.c
source code for your
system (see your Unix manual).
6.1 Configuration
The
Port Setup Menu
should be set up as follows for both
simple dial-in connections and PPP/SLIP connections.
** Administrator ** PORT SETUP MENU REMOTE-ADMIN
Hardware Flow ctrl Keys
Speed [57600 ] Flow ctrl [Hardware] Hot [^@] Intr [^@]
Parity [None] Input Flow [Enabled ] Quit [^@] Kill [^@]
Bit [8] Output Flow [Enabled ] Del [^@] Sess [^@]
Stop [1 ] Echo [^@]
Break [Disabled] IP Addresses
Monitor DSR [No ] Src [ ] Mask [ ]
Monitor DCD [Yes] Dst [206.189.134.7 ]
User Options Access
Name [ ] Keepalive [No ] Access [Dynamic]
Terminal type [ansi ] Rlogin/Telnet [Telnet] Authentication [None ]
TERM [ ] Debug options [No ] Mode [Raw ]
Video pages [0] Map CR to CR LF [No ] Connection [None ]
CLI/Menu [CLI ] Hex data [No ] Host [ ]
Reset Term [No ] Secure [No ] Remote Port [0 ]
MOTD [No ] Local Port [10006]
________________________________________________________________________________
Figure 22: Port Setup Menu screen.
To Next Page
Loading...
