To Next Page

To Previous Page

PAL-AT Installation Manual

4.2 Calibration Points ........................................................................................................... 21

4.3 Junction Boxes ............................................................................................................... 21

5 Cable Installation in Secondary Contained Piping ............................... 22

5.1 General .......................................................................................................................... 22

5.2 Pull Points ...................................................................................................................... 23

5.3 Cable Splices ................................................................................................................. 25

5.3.1 Factory Installed Fiber Pull Rope to Continuous Pull Wire Rope Splice .............. 25

5.3.2 Wire Rope to Wire Rope Splice ........................................................................... 26

5.3.3 Wire Rope to Wire Rope Splice (alternate).......................................................... 27

5.3.4 Wire Rope to Leak Detection Cables .................................................................. 28

5.4 Installation of the Continuous Pull Rope ........................................................................ 30

5.5 Installing Sensor and Jumper Cables ............................................................................. 32

5.6 Air Testing ...................................................................................................................... 35

6 Installation of Direct Buried Sensor Cable ............................................ 36

6.1 General .......................................................................................................................... 36

6.2 Installing the Sensor Cable ............................................................................................ 37

6.3 Above Ground Storage Tanks ........................................................................................ 40

7 Cable Installation for Raised Floor and Ceilings .................................. 42

7.1 General .......................................................................................................................... 42

7.2 Install the Sensor Cable ................................................................................................. 42

7.3 Locator Chart ................................................................................................................. 43

7.4 Calibration and end of run Access Points ...................................................................... 43

8 Cable Connectors ................................................................................... 44

8.1 General .......................................................................................................................... 44

8.2 Cable Connector Installation .......................................................................................... 44

8.2.1 CAGOLD and CATFH Connectors for Sensor Cables AGW-Gold, AGT-Gold,

TFH-Gold and TFH .............................................................................................. 44

8.2.2 CAJMP Connectors for Jumper Cables JMP-U/-UD ........................................... 47

8.2.3 CAJPP Connectors for Jumper Cables JPP and JMP ......................................... 49

8.2.4 CAGOLD Connector for ATP Cable .................................................................... 50

8.3 Shrink Tubing ................................................................................................................. 52

8.3.1 Cable Type TFH .................................................................................................. 52

8.3.2 Cable Types AGW-Gold, AGT-Gold and TFH-Gold ............................................ 53

8.3.3 Cable Types JMP-U/-UD, JPP and JMP ............................................................. 54

8.4 Cable and Connector Testing Procedures ..................................................................... 54

8.4.1 General................................................................................................................ 54

8.4.2 Continuity Test .................................................................................................... 54

Permalert PAL-AT AT30C Installation Manual

Other manuals for Permalert PAL-AT AT30C