Persistent Systems Wave Relay MPU5 - Perform a Throughput Test

© 2010 - 2018 Persistent Systems, LLC – All Rights Reserved
72
TESTING CONNECTIVITY: THROUGHPUT TEST
Perform a Throughput Test
1
Click the Node Status tab.
2
Click the Bandwidth Test button.
3
Select a destination node for the through-
put test from the Destination drop-down
menu. This menu is populated from the
Node List.
4
Enter the desired test duration (in sec-
onds) in the Test Duration field.
Note: Persistent Systems recommends the test
duration to be set to a minimum of 5 seconds.
5
Check or uncheck the Upload only test
box. If this box is checked, only upload
speed to the destination node will be test-
ed.
6
Click Run Test and wait for the test to com-
plete.
7
The page will display the upload speed to
and download speed from the destination
node.
!
WARNING!: During long duration tests,
data will continue to be sent for the full
specified duration even if a different data
flow is started or the web browser is exit-
ed.