The display will alert the driver to high and
low temperature conditions. When the
outside temperate approaches freezing
(36°F or 2°C) an icon will appear next to
the temperature (snowflake for freezing
and thermometer for high) and a chime will
sound. The system's unit of measure
(Fahrenheit or Celsius) can be changed by
navigating to the settings menu. The
outside air temperature display uses a
sensor (located at the bottom of the
driver's side mirror assembly) to measure
outside air temperature only. It is not
capable of displaying the temperature of
the road surface on either the temperature
display or the snowflake icon. Additionally,
the outside air temperature reading may be
affected by exposure to direct sunlight.
Diesel Particulate Filter (DPF)
Status
The Diesel Particulate Filter indicator
shows the soot load percentage. This
indicator will change colors as the soot
load increases (see Guide to the Warnings
Symbols or your Engine Aftertreatment
Operator Manual for more details).
View Indicator
The View Indicator identifies which view is
currently selected:
• Favorites (if enabled)
• Minimized
• Minimized with Advance Driving
Assistance (Optional)
• Basic
• Enhanced
Drive, Neutral, and Reverse
Indicator
The Drive, Neutral, and Reverse Indicator
reflects the shifter position of an Automatic
Transmission. Manual transmissions and
certain automatic transmission do not
provide feedback to the display. Instead,
the transmission shifter indicates the gear
condition.
Sub-trip Odometer
The Trip Odometer can be split into smaller
segments called Sub-trips. Start a Sub-trip
by pressing Trip on the steering wheel.
The maximum distance that the sub-trip
will show is 9,999.9 at which point it will
start over at zero. When it maxes out, the
current sub-trip ends and begins a new
one. Sub-trip information is also found in
the settings menu
Trip Summary on page
64.
Trip Odometer
The Trip Odometer shows how far the
vehicle has gone traveled since last it was
reset. The maximum distance that can be
shown on the Trip Odometer is 99,999.9 at
which point the operator needs to reset.
CONTROLS - Peterbilt Digital Display
Y53-6076-1D1 (09/20) 57
3
To Next Page
Loading...
