c)
above
When the machine Is inoperative, there should be a clearance of
about
764"
between starting lever Eand brake lever H. To adjust, turn screw G in or
out, or reset fork J. (See Fig. 83).
=sq5
d)
and
e)
above
The chain should be slack throughout the sewing action. To check this, proceed
as
follows:
Turn the machine by
hand
o full cycle
and
see
whether
the chain is slack
at
all times. The chain must not be too loose, however, as otherwise the upward
travel of the
magnet
plunger
would be shortened.
If adjustment is required, set fork J either higher or lower.
89
To Next Page
Loading...
Need help?
General
