Pfaff 3538-30/02

Operating Controls
19
 F4 key
The unit continues to sew after the "Remove fabric" message although there is still mate-
rial under the initial light barrier.
 Scroll
If this key is pressed, the input menus on the display are scrolled through.
 TE key
The machine changes from sewing mode to stitch input mode if this key is pressed.
 Piece counter / counter
These keys can be used to switch between the piece counter and the counter. If the re-
spective function is switched on, a menu appears to set the counter to a preset, variable
value when pressing the key.
Coded via parameters 811 and 812.
The piece counter key corresponds to number 0 when entering the code number.
 Separate chain (with subclasses 2 and 3)
The chain cutter is activated once after pressing the key.
 Raise/lower band feed
This is raised if the band feed is lowered and lowered if the band feed is raised. Coded
via parameter 813.
 Raise/lower presser foot
This is raised if the presser foot is lowered and lowered if the presser foot is raised. Cod-
ed via parameter 813.
 Band feed forwards
The band feed moves forward while the key is pressed.
Coded via parameter 813.
 Band feed backwards
If the band feed is raised, the band feed moves backwards while the key is pressed.
Coded via parameter 813.
F4
0
0
0
0
0
0