Input
31
10.04 Input mode
Enter parameters
Fig. 10 - 04
F1
F2
F3
F4
0
0
0
0
0
0
No
505
16,4
VAL
The display shows the selected parameter number on the left and the associated parame-
ter value further to the right. Parameter 505, the clearance from the chain cutter sensor to
the chain cutter has been selected in the example above. The displayed parameter value is
16.4 mm.
The values above can be changed using the plus/minus keys. The parameter values are tak-
en over by advancing to another parameter number.
If the TE key is pressed, the values are also taken over and the machine switches to sewing
mode.
+
–
To Next Page
Loading...
