Input
29
10.03 Input mode
Select the function group
The desired function group must be selected using the allocated plus/minus key after chang-
ing to input mode.
Select the function group or function with the corresponding plus/minus key.
The upper key is + and the lower key is -.
The selected function group is taken over by pressing the plus/minus key under the En-
ter symbol and the machine jumps to the “Enter parameter” status after entering the code.
This display does not appear if the access code has already been entered or the function
group is not code protected.
If the TE key is pressed, the machine changes to production mode (LED off).
Fig. 10 - 03
F1
F2
F3
F4
0
0
0
0
0
0
No
500
+
–
To Next Page
Loading...
