Maintenance and Care
38
These maintenance intervals are based on an average running time of a single
shift production shop. Shorter maintenance intervals are recommended for in-
creased running times.
11.02 Cleaning the machine
The required cleaning cycle for the machine depends on the following factors:
Single or multi-shift operation
Dust formation caused by the workpieces
Optimal cleaning instructions can therefore only be determined on a case-by-case basis.
Disconnect the machine from the electricity mains for all cleaning work by shut-
ting off the main switch or removing the mains plug! Risk of injury due to acci-
dental machine start-up!
The following tasks are recommended during a single shift operation to avoid operational er-
rors:
Open the hook area cover.
Clean the hook area daily, more frequently during continuous operation.
Close the gripper area cover!
Only operate the machine when the hook room cover is closed!
Risk of injury due to moving parts!
11 Maintenance and Care
11
.01 Maintenance intervals
Cleaning the hook area .............................daily, several times during continuous operation
Cleaning the complete machine ............................................................................... weekly
Machine oil level .................................................................................. daily, before start-up
Checking / setting the air pressure ...................................................................... as needed
Cleaning the maintenance unit air fi lter ............................................................... as needed
To Next Page
Loading...
