2:7
Preparations
Changing the needle
Switch off the main switch
To remove: Lower the presser foot and set the needle to its highest
position. Loosen the needle screw and pull the needle out downwards.
To insert: The fl at side of the needle must face to the rear. Keep the
presser foot down and insert the needle, pushing it up as far as it will
go. Hold the needle and tighten the needle screw fi rmly.
Bobbin winding
Preparing the machine for bobbin winding
Place an empty blue bobbin on the bobbin winder aligning the small
rectangular hole on the bottom side of the bobbin with the small pin on
the bobbin winder. The Pfaff logo is facing up.
Push the bobbin to the right.
Note: The bobbin can only be wound if it is moved fully to the right.
To Next Page
Loading...
