3:5
Embroidery
Function buttons for
embroidery
This section contains the function buttons active
when the machine is in embroidery mode (the
embroidery unit is on).
Park position
The park/cut position button (65) is used for put-
ting the embroidery unit in the correct position
for storage or placing it in the embroidery case
(optional accessory). The letter P will be shown on
the window.
Orbiting button
The orbiting function makes it possible for you to
check the outlines of your design. For each touch
of the orbiting button (66) the hoop will move to a
corner starting with the upper left. An arrow will
fl ash beside the hoop on the window showing you
which corner the needle is in.
Embroidery design/font select button
The embroidery design/font select button (67) is
used for switching between designs and fonts. If a
card contains only fonts, a number for each font will
be shown on the window. If a card contains only
designs or both designs and fonts, the small hoop
icon will be shown in the window when a design is
selected.
Cut position
If you press the park/cut position button two times
quick the hoop will move forward to make it easier
for you to cut jump stitches. This function can also
be used when cutting away the fabric in an appliqué
design, without having to slide off the hoop.
The letter C will be shown on the window. Press the
button one more time and the hoop will move back
to the next stitch point in the embroidery.
To Next Page
Loading...
