4:4
A
B
C
Stitch width
The width of a stitch is shown in mm (A).
Change the stitch width by pressing the + and - buttons (51). The stitch
width can be changed in 0.5 mm steps, from 0 mm to 9.0 mm. When
you have reached the limit you will hear a beep.
Stitches 1, 2 and 14 are side position stitches. This means that you can
use the + and - buttons to change the needle position of these stitches.If
you have changed the preset value of one of these stitches, you will see
an arrow in the window pointing in the direction you have chosen.
Stitch length
The length of a stitch is shown in mm (B).
To change the stitch length press the + and - buttons (52). The length
for normal stitches can be changed in 0.5 mm steps from 0-6 mm. For
satin stitches you can change the stitch density length in 0.1 mm steps
from 0-1.5 mm.
When you have reached the limit you will hear a beep.
Thread tension
Press the + and - buttons (53) to change the thread tension (C). To read
more about thread tension see page 2:18.
When you have reached the limit you will hear a beep.
To Next Page
Loading...
Need help?
General
