3:16
Appliqué embroidery
To embroider an appliqué design, place a stabilizer underneath the
fabric and hoop all the layers. Start to embroider. A straight stitch
outline is stitched around the appliqué design. When the machine stops
and you see an A in the display, place the appliqué fabric on top.
Start your machine again, and the machine will sew a straight stitch
outline around the appliqué section of the design. When the machine
stops the second time, slide off the hoop but do not take the fabric out
of the hoop. Carefully trim around only the appliqué fabric outside the
straight stitch line.
Slide the hoop back onto the embroidery unit and continue embroider-
ing to fi nish the appliqué edges and the entire embroidery.
Note: If you put the hoop in cut position when the machine stops you can
cut away the fabric without having to slide off the hoop.
Cutwork embroidery
To embroider cutwork designs, place a stabilizer underneath the fabric
and hoop all layers. Start embroidering. A straight stitch outline is
stitched around the cutwork design. When the machine stops and an A
is shown in the display, remove the hoop but do not take the fabric out
of the hoop. Carefully cut away the fabric from inside the straight stitch
outline making sure you do not cut away the stabilizer. To fi nish, slide
the hoop back onto the embroidery unit and continue embroidering.
To Next Page
Loading...
