2:12
A
B
C
D
Threading your creative 2134
Raise the presser foot. Place the thread on the spool
pin and fi t a spool cap, either the same size or
slightly larger than the spool, on top of the spool.
Using both hands, pull the thread into thread guide
A from the front. Place the thread from right to left
into the pretension guide B.
Now pass it through the left threading slot down-
wards through the left-hand side of the tension disk.
Pull the thread around the stop C and into the right
threading slot and upwards to the take-up lever. The
thread must be pulled into the take-up lever from
left to right. Pass the thread downwards in the right-
hand threading slot.
Pull the thread from the side behind one of the two
thread guides D.
To Next Page
Loading...
Need help?
General
