2:2
123
Preparations
Unpacking
1. Place the box on a steady, Á at surface. Lift the
machine out of the box and remove the outer
packaging and lift off the machine carrying
case.
2. Remove all other packing material and the
plastic bag.
3. Slide off the accessory tray and remove the
styrofoam inside.
Note: Styrofoam left in the accessory tray while sewing
may affect stitch quality. The styrofoam is for packing
purposes only and should be removed.
Connecting the foot control cord
Among the accessories you will À nd the foot
control cord. Connecting the foot control cord to
the foot control is only neccessary the very À rst
time you are going to use the machine.
1. Take out the foot control cord. Turn the foot
control over. Connect the cord to the socket
inside the space of the foot control.
2. Push À rmly to make sure it is properly
connected.
3. Lay the cord in the slot on the underside of the
foot control.
Connect the power cord and foot control
Note: Before plugging in the foot control, check to
ensure that it is type “FR5” (see underside of foot
control).
1. Connect the foot control cord to the front
socket on the bottom right side of the machine
(1).
2. Connect the power cord to the rear socket on
the bottom right side of the machine (2). Plug
the cord into the wall socket.
3. Press the ON/OFF switch to ON to turn on
power and light (3).
For the USA and Canada
This sewing machine has a polarized plug (one
blade wider than the other). To reduce the risk
of electric shock, this plug is intended to À t in a
polarized outlet only one way. If the plug does not
À t fully in the outlet, reverse the plug. If it still does
not À t, contact a qualiÀ ed electrician to install the
proper outlet. Do not modify the plug in any way.
To Next Page
Loading...
Need help?
General
