2:14
Preparations
8. You may now connect your embroidery
machine to your computer. A message will
appear and you will be informed when your
embroidery machine is ready to be used.
Windows® XP
6. From the main menu of your CD, click the
Install Drivers option for Windows® XP.
Drivers are only available for 32-bit Windows® XP.
7. During the installation process, if existing
drivers are found, you will be informed that
drivers have been removed and that the
computer must be restarted. Click OK to restart
the computer. Installation will resume after the
computer has restarted.
8. At the end of the installation you will be
prompted to connect your embroidery
machine. Click Finish on the last page. Leave
your 5D™ Embroidery System software CD in
your computer.
9. The Found New Hardware wizard will appear.
Select ’No, not at this time’ on the À rst page
then click Next. Select ’Install the software
automatically’ then click Next. A warning will
appear that the drivers are not signed. This is
normal and should not be a cause for concern.
Click Continue Anyway and the driver
installation will complete automatically.
How to launch the programs
Shortcuts on the Desktop
1. Double-click on the Shortcut to the 5D™
Embroidery System program folder. A list of
programs appears.
2. Double-click on 5D™ Organizer, 5D™
QuickFont or 5D™ ConÀ gure to launch it.
Alternatively use the Start Menu to open modules
under Start, All programs, 5D™ Embroidery
System.
Embroidery Machine Communication
module
The Embroidery Machine Communication
module must be active (
or ) to use your
embroidery machine with your computer. The
icons are found in the lower right corner of your
computer screen. If the Embroidery Machine
Communication module is not active, it may be
started from the Send tab of 5D™ ConÀ gure.
How to update your machine
Be sure to consult the web site at
www.pfaff.com and/or your local authorized
PFAFF® dealer for updates and upgrades for your
machine and Owner’s manual.
You can update your machine using the USB
embroidery stick or the USB cable packed with
your machine (P/N:412 62 59-04).
Updating instructions
• Go to the PFAFF® web site at www.pfaff.com
to À nd information about available updates.
• Follow the update wizard to prepare your USB
embroidery stick for the update.
• While pressing and holding the stitch restart
button and needle up/down button, turn your
machine on to start in update mode. Follow the
instructions on the PFAFF® HD screen to update.
Viewing and printing PDF Guides
To À nd all the Reference and Sample Guides for
you 5D™ Embroidery System software go to
Start, All Programs, 5D™ Embroidery System
then choose Reference Guides or Sample Guides.
Choose relevant folder then select the desired PDF
Guide. Double-click on the desired name to launch
the relevant .pdf À le if you have Adobe Acrobat
installed on your computer. To install the Acrobat
Reader, insert the 5D™ Embroidery System CD
and select that option from the menu that appears.
To Next Page
Loading...
Need help?
General
