4:9
21
10
12 13 14
Sewing mode
Stitch positioning (21)
For straight stitches the stitch positioning icon (21)
is shown instead of the stitch width icon. Use +
to move the needle to the right and - to move the
needle to the left. For straight stitches the machine
has 37 needle positions.
It is possible to change the stitch position of all
stitches. Touch the width/position toggle (10)
icon to toggle between stitch width and stitch
positioning. The stitch position can only be
changed to the limit of the maximum stitch width.
Changing the stitch position will also limit the
stitch width adjustment.
Stitch length (12)
Increase or decrease the stitch length using + and
-. If lengthening a zigzag stitch or a decorative
stitch, the entire stitch will be longer. If lengthening
a satin stitch where the density can be adjusted,
the entire stitch will be longer but the density will
remain the same.
Stitch density (13)
The stitch density control adjusts the density (the
closeness of the satin stitches that make up the
entire stitch). The density does not affect the actual
length of the entire stitch.
Touch + to decrease the density. Touch - to increase
the density.
Note: This is often used with specialty threads and when
a less dense satin stitch is desired.
Stitch length +Stitch length -
Stitch density -Stitch density +
To Next Page
Loading...
Need help?
General
