7:6
D
Embroidery preparations
7. Clear sufÀ cient space to accommodate
movement of the embroidery arm and the
hoop. Hold the needle thread and touch the
start/stop button (D) or the foot control. The
machine starts embroidering.
8. After stitching a few stitches, the machine stops
and a pop-up appears on the screen asking you
to cut the thread end. Cut the thread and press
start/stop to continue embroidering.
9. When the À rst color is completed, your
machine stops. A pop-up appears asking you
to change color. Re-thread with the next color
and continue embroidering by pressing start/
stop.
Each color segment is tied off at the end and
the needle thread is cut.
10. When the embroidery is completed, your
machine cuts the needle and bobbin thread
and stops. The needle and presser foot raise
automatically for easy removal of the hoop.
A pop-up informs you that your embroidery is
À nished. Touch OK to clear your design from
the screen.
To Next Page
Loading...
Need help?
General
