14
BG 5195 BEN / A (2011-05) TPG261.oi
3 Installation
Skilled personnel
The unit may only be installed by persons
who have suitable technical training and the
necessary experience or who have been
instructed by the end-user of the product.
The TPG 261 is suited for incorporation into a 19" rack
or a control panel or for use as desk-top unit.
DANGER
Putting a product which presents a visible
damage into operation can be extremely
hazardous. If the product presents a visible
damage do not put it into operation and make
sure it is not inadvertently put into operation.
The TPG 261 is designed for installation into a 19" rack
chassis adapter according to DIN 41 494. For this pur-
pose, four collar screws and plastic sleeves are supplied
with it.
DANGER
DANGER: protection class of the rack
If the product is installed in a rack, it is likely
to lower the protection class of the rack
(protection against foreign bodies and water)
e.g. according to the EN 60204-1 regulations
for switching cabinets.
Take appropriate measures for the rack to
meet the specifications of the protection
class.
3.1 Personnel
3.2 Installation, Setup
3.2.1 Rack Installation
To Next Page
Loading...
