BG 5195 BEN / A (2011-05) TPG261.oi 25
Make sure the TPG 261 is correctly installed and the
specifications in the Technical Data are met.
The power switch is on the
rear of the unit.
Turn the TPG 261 on with
the power switch (or cen-
trally, via a switched power
distributor, if the unit is in-
corporated in a rack).
After power on, the TPG 261 …
• automatically performs a self-test
• identifies the connected gauge
• activates the parameters that were in effect before
the last power off
• switches to the Measurement mode
• adapts the parameters if required (if another gauge
was previously connected).
Turn the TPG 261 off with the power switch (or centrally,
via a switched power distributor, if the unit is incorpo-
rated in a rack).
Wait at least 10 s before turning the TPG 261
on again in order for it to correctly initialize it-
self.
4.2 Turning the
TPG 261 On and Off
Turning the TPG 261
on
Turning the TPG 261
off
To Next Page
Loading...
